OPERATION
Troubleshooting
Please check for causes of problems in accordance with the following chart before contacting your dealer
or any service personnel.Symptom | Cause | Correction | |
| Signal not properly connected. | Connect signal securely. | |
No sound | Disc warped or dirty. | Clean your disc. | |
| Player in mute status. | Press MUTE button again. | |
|
|
| |
No picture | Signal not properly connected. | Connect signal securely. | |
TV not set for correct system | Reset the AV/TV status of your TV set | ||
| |||
| DVD55/57/59 set to progressive scan mode. | Press the Interlace scan button on the remote (See page 27). | |
|
|
| |
No colour | TV system not correct | Press P/N button on the remote control to set the system. | |
TV set colour not properly adjusted. | Readjust colour of your TV set. | ||
| |||
|
|
| |
| No disc in the player. | Load a disc. | |
No disc reading | Disc not properly loaded. | Reload a disc, with the label side facing up. | |
| Condensation on the laser head. | Turn on the player, unload the disc and leave it on for about one hour. | |
|
|
| |
Remote control | Remote control not pointing to the sensor | Use the remote control properly. | |
window. | |||
| |||
failure | Remote control's operating distance more | Replace both batteries. | |
than 8 metres away from your TV set. | |||
| |||
| Batteries low. |
| |
|
|
| |
Temporary | Faulty disc used. | Wait 5~10 seconds for it to eject and replace with another disc. | |
Wrong buttons pressed. | Operate once more. | ||
function failure | |||
Static leakage into the player from outside. | Turn off the player for 1 to 2 minutes, then turn it on again. | ||
|
Picture rolling
TV set system is not properly adjusted.
Readjust system of your TV set in the menus.
Page 29