Cambridge SoundWorks FPS1800 manual Thread satellite cable through hole in desktop stand

FPS1800.fm Page 3 Tuesday, July 18, 2000 4:48 PM

❒Mount the rear satellites only on walls that are structurally sound.

1Drill a hole about 0.5 cm (¼ inch) deep into wall.

2Tap plastic anchor into hole until it is flush with wall.

3Screw a M5 x 25 mm screw into anchor, leaving about 0.5 cm (¼ inch) protruding.

5 Slip keyhole slot of each rear satellite onto protruding screw.

❒Position the satellites behind you and slightly above ear level.

4 Apply rubber pads on the back of each rear satellite.

1 Apply identification label to back of satellite.

3 Thread satellite cable through hole in desktop stand.

Note: Typically, the shorter 3-meter cables are used for the front satellites.

2 Push back red tab on satellite. Insert bare end of red-banded cable into hole and release tab to lock. Repeat for unmarked cable; insert into black tab.

4 Insert attachment arm into socket at back of satellite.

Attachment arm.

5 Apply identification

label to cable.

3