4 OPERATION
P.21
4.7 Filter Cleaning
The air intake on the front of your VORTEX is fitted with a removable filter system. If the filter becomes clogged, the unit will not cool as efficiently as it should and may result in reduced output levels.
VORTEX Filter Assembly
1 Clip Apertures
2 Injection Moulded Cradle
3 Foam Filter
4 Injection Moulded Surround
5 Injection Moulded CAMCO Badge
USER MANUAL
VORTEX 6, 4, 2.6 and 200V
For changing the filter, no tools are required: first, gently slide the whole plastic filter assembly a few millimetres to the left and lift it from the front panel. Next, beginning on one of the long sides, carefully unclip the moulded surround (4) from the cradle (2) and then carefully pull the CAMCO badge (5) out of the four fastening holes with both hands. Remove the foam filter (3) and clean it with a mild dishwashing detergent and warm water. Once dry, replace the foam filter carefully into the cradle and repeat the dismantling procedure in reverse. Insert the five pins on the filter frame into the clip apertures (1) and slide the filter carefully to the right to secure.
3
4
5
1
2