Before you call for service…

www.GEAppliancesCanada.com

Troubleshooting Tips

Save time and money! Review the chart on this page first and you may not need to call for service.

SAFETY NOTE: Before investigating, you must disconnect the power supply.

WARNING!

Before resetting, disconnect the power supply–please see SAFETY NOTE above. The overload control prevents the motor from operating should overloading occur. This feature protects your house wiring and your disposer. When overloaded, the motor will stop automatically.

Problem

Possible Causes

What To Do

Loud noises (other than

Silverware, bottle cap or other

Remove the splash guard* and remove the object with

those during grinding of

foreign object has fallen into the

long-handled tongs. Replace the splash guard*.

bones and fruit pits)

disposer.

 

Disposer does not start

Reset button has been tripped.

With the splash guard* removed, check to see if the

 

 

turntable will move freely using a broom handle. If the

 

 

turntable moves freely, replace the splash guard* and

 

 

check the reset button to see if it has been tripped. The

 

 

reset button is red and located opposite the discharge

 

 

elbow, near the bottom of the disposer. Push the button

 

 

in until it clicks and remains depressed. If the reset

 

 

button has not been tripped, check for a shorted or

 

Reset

broken wire connecting to the disposer. Check the

 

electrical power switch, fuse box or circuit breaker.

 

Button

If wiring and electrical components are intact, the

 

Serial No.

 

unit may have internal problems that require

 

 

service or replacement.

Turntable cannot rotate. If the turntable does not turn freely, check for an object lodged between the turntable and the grind ring. Dislodge the object by moving the turntable with a broom handle. Then remove the object.

If no foreign object is present, there may be internal problems.

Remove

Splash Guard

Turntable

Disposer leaks

If the leak is at the top, it may be

caused by:

1.Improper seating of sink flange (gasket choice, putty or tightening).

2.Support ring not tightened properly.

3.Defective cushion mount.

If the leak is at the discharge elbow, leak may be caused by improper tightening of elbow flange screws.

*Batch Feed does not include splash guard.

11

Safety Instructions Installation Instructions Operating Instructions Troubleshooting Tips Consumer Support

Page 11
Image 11
Camco GFC1022F, GFC500F, GFC700F, GFB762F owner manual Before you call for service…