Camco GFC1022F, GFC500F Important Safety Instructions, HOW TO CONNECT ELECTRICITY cont, Support

IMPORTANT SAFETY INSTRUCTIONS.
READ ALL INSTRUCTIONS BEFORE USING.	www.GEAppliancesCanada.com

WARNING!

HOW TO CONNECT ELECTRICITY (cont.)

If you are not familiar with electrical power and procedures, call a qualified electrician.

Safety Instructions

The power cord and/or connections must comply with the National Electrical Code.

For Models Not Equipped with a Cord:

If your disposer does not come equipped with a cord, you can connect it in two ways:

1.Attach a power cord, minimum 18″ in length and not to exceed 36″ in length.

C.Use a cable clamp
strain relief
connector where	Strain Relief
power cord enters
the disposer.
	Nut

Installation

or

2.Wire the disposer directly into the house current.

To Attach a Power Cord:

GROUNDING INSTRUCTIONS: This appliance must be grounded. In the event of malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. The power cord (to be installed) must have an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

DANGER: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded.

NOTE: Disconnect electric power to disposer circuit before installation. Turn the circuit breaker to the OFF position or remove the fuse.

A.Connect the disposer to 110–120 Volt, 60 Hz AC current only.

B. If a plug-in cord is used, use a three-prong plug.

Ground wire	Trace lead connected to this
should be	blade and attach that lead
attached to
	to white wire on disposer. Ribbed Side
the ground
screw in the
bottom of
the disposer
(end bell).	NOTE: When viewing face of electrical plug
	with grounding pin at top, the larger left blade
	is connected to the identified wire.

To Wire Your Disposer Directly into the House Current:

GROUNDING INSTRUCTIONS: This appliance must be connected to a grounded, metal, permanent wiring system; or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the appliance.

A.If you use BX cable:

1.Install the cable connector in the hole.

2.Connect white wire to white lead of disposer.

3.Connect black wire.

4.Connect bare ground wire.

If BX cable is not used, provide a separate ground wire to nearest reliable ground, using the screw in the end bell for the ground wire.

	Red Reset Button
	Ground Screw
To House Current	Wire Nuts
	Remove
or Power Cord
	Cover Plate

Bottom of the Disposer (end bell)

B. If your power supply does not include a ground wire, you must provide one unless metal cable is used. Attach a copper wire securely to disposer ground screw and attach other end of wire to a reliable ground. Use only CSA approved ground clamp. If plastic pipe is used in your home, a qualified electrician should install a proper ground.

Instructions Operating Instructions Troubleshooting Tips Consumer

READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

SAVE THESE INSTRUCTIONS 3

Support