Campbell Hausfeld CHN70500, IN729900AV Head, Length, Finish, Model #, Fasteners, Collation, Shank Gauge, Nails Per Box, Nails Per Stick, Replacement Parts, Technical Service, Battery Replacement

Operating Instructions and Parts Manual CHN70500

Maintenance (Continued)

Replacement Parts

Use only genuine Campbell Hausfeld service parts.Tool performance, safety and durability could be reduced if improper parts are used.When

ordering replacement parts, specify by part number.

Battery Replacement

Always disconnect the tool from the power source when unattended, performing any maintenance or repair, clearing a jam, loading,

unloading , or moving the tool to a new location.

The electronics on the tool (low nail indicator lights and nail placement laser pointer) run off of two (2) AAA batteries located in the compartment on the back of the magazine. When the batteries’ power is running low and they need to be replaced, the electronic functions may not work properly or at all. Disconnect the tool from air

source and remove the battery compartment cover by squeezing the locking tab and Figure 25 - Battery Replacement pulling out. Insert two (2) new batteries in the proper orientation. Do not mix old and

new batteries. Close cover.

Assembly Procedure For Seals

When repairing a nailer, the internal parts must be cleaned and lubricated. Parker O- lube or equivalent must be used on all o-rings. Each o-ring must be coated with O-lube before assembling. A small amount of oil must be used on all moving surfaces and pivots.

Technical Service

For information regarding the operation or repair of this product, please call 1-800- 543-6400.

Fastener Interchange Information

Fasteners used in the Campbell Hausfeld CHN70500 Angle Finish Nailer will also work in the following brand units:

•	Campbell Hausfeld NB0064	•	Ridgid R250SFA
•	Craftsman 18175, 18314	•	Senco Finish Pro 32

•Porter Cable FN250

Fasteners

The following Campbell Hausfeld brad nails are available at local retail stores. For help locating any item, call customer service at 1-800-543-6400. Campbell Hausfeld nails meet or exceed ASTM Standard F1667.

Model #	Length	Shank Gauge	Finish	Head	Collation	Nails Per Stick	Nails Per Box
FB005060	2 inch	16 Gauge	Galvanized	Brad	Adhesive	50	2500
FB160025	1 inch	16 Gauge	Galvanized	Brad	Adhesive	50	1000
FB160040	1-1/2 inch	16 Gauge	Galvanized	Brad	Adhesive	50	1000
FB160050	2 inch	16 Gauge	Galvanized	Brad	Adhesive	50	1000
FB160065	2-1/2 inch	16 Gauge	Galvanized	Brad	Adhesive	50	1000

16www.chpower.com