Operating Instructions
Troubleshooting Chart
Stop using stapler immediately if any of the following problems occur. Serious personal injury could occur. Any repairs or replacements must be done by a Qualified Service Person or Authorized Service Center.
Symptom | Possible Cause(s) | Corrective Action | ||
Air leaking at trigger valve | Replace | |||
area. | damaged | Contact Element (WCE) | ||
Air leaking between housing | 1. Damaged | 1. | Replace | |
and nose. | 2. | Damage to bumper | 2. | Replace bumper |
| ||||
Air leaking between housing | 1. Loose screws | 1. | Tighten screws | |
and cap. | 2. | Damaged gasket | 2. | Replace gasket |
| ||||
Nailer skips driving nail | 1. Worn bumper | 1. | Replace bumper | |
| 2. | Dirt in nose piece | 2. | Clean drive channel |
| 3. | Dirt or damage prevent staples or pusher | 3. | Clean magazine |
|
| from moving freely in magazine |
|
|
| 4. | Damaged pusher spring | 4. | Replace spring |
| 5. | Inadequate air flow to stapler | 5. | Check fitting, hose, or compressor |
| 6. | Worn | 6. | Replace and lubricate |
|
| lubrication |
|
|
| 7. | Damaged | 7. | Replace |
| 8. | Air leaks | 8. | Tighten screws and fittings |
| 9. | Cap gasket leaking | 9. | Replace gasket |
|
|
|
| |
Nailer runs slow or has loss | 1. Nailer not lubricated sufficiently | 1. | Lubricate nailer | |
of power | 2. | Broken spring in cylinder cap | 2. | Replace spring |
| ||||
| 3. | Exhaust port in cap is blocked | 3. | Replace damaged internal parts |
|
|
|
| |
Nails are jammed in nailer | 1. Guide on driver is worn | 1. | Replace guide | |
| 2. | Nails are not correct size | 2. | Use only recommended nails |
| 3. | Nails are bent | 3. | Replace with undamaged nails |
| 4. | Magazine or nose screws are loose | 4. | Tighten screws |
| 5. | Driver is damaged | 5. | Replace driver |
www.chpower.com
8