Pressure Washer

Operation

Low Pressure

Nozzle

High Pressure

Figure 13 - Adjusting nozzle for pressure

General Cleaning Tips

1.Apply the detergent so that it thoroughly covers the cleaning surface.. Apply the detergent from bottom to top to prevent the detergent from sliding down and streaking.. Wait a couple of minutes for the detergent to break down the dirt and grime.. Use a brush to lightly scrub heavily soiled areas.. Never allow the detergent to dry on the cleaning surface..

2.To rinse or to return the nozzle to high pressure, release the trigger and slide the nozzle to the high pressure setting..

never make the nozzle pressure adjustment with the gun triggered.

Adjusting the high-low nozzle when the gun is triggered can result in damage to the seals in the nozzle.

3.After using detergents, flush the suction system by placing the detergent suction tube into a bucket of clean water..

5.Cleaning Power

The easiest way to regulate the cleaning power of your pressure washer is by changing the distance from the surface you are cleaning.. Begin spraying while standing several feet from the surface. Slowly move closer to the object you are cleaning until you find the most effective cleaning technique..

6. Final Rinse

The final rinse should start at the bottom and work upward.. Make sure that you thoroughly rinse the surface and that you remove all detergent..

7. Pressure Relief Procedure

To reduce the risk of bodily injury or property damage, always follow this procedure whenever spraying is stopped, when work is completed, and before checking or repairing any part of the system..

1.. Engage the trigger safety latch..

2.Turn the unit off..

3.Shut off the water supply..

4.Disengage the trigger safety latch and trigger the gun to relieve pressure..

5.Re-engage the trigger safety latch..

6..When checking or repairing unit, remove the ignition cable from the spark plug.. .

7.Before overnight storage, long term storage, or transporting unit, disconnect the water supply and turn off the fuel supply valve..

8.Shutdown

1.. Be sure all detergent is flushed from system.. 2. Turn the engine OFF..

3 Turn the water supply OFF..

4.After the engine and water supply are turned off, trigger the gun to depressurize the system..

neVER turn the water supply off before turning the engine/motor off. Serious

damage could occur to the pump and/or engine/motor.

neVER disconnect the high pressure discharge hose from the machine while

the system is pressurized. To depressurize, turn engine/motor off, turn water supply off and squeeze gun trigger 2-3 times.

5.After each use, wipe all surfaces of the pressure washer with a clean, damp cloth..

•Do not store the pressure washer outdoors.

•Do not store the pressure washer where it might freeze unless it has been properly winterized..

9.Storage

long term storage instructions (more than 30 days in storage)

1..Remove fuel from the tank and run the pressure washer in a normal operating mode until the engine stops from a lack of fuel.. Normal operating mode means actually spraying water from the gun while the engine is running..

Alternate method – Add fuel stabilizer to gas in the tank and run in normal operating mode for at least five minutes..

2..Stop the engine, turn off the water supply, and trigger the gun to release pressure in the high-pressure hose..

3.Disconnect the water supply and high pressure hose from the pump..

4.Allow the engine to cool..

5.Disconnect the spark plug wire and remove the spark plug..

6.Pour 1/2 oz.. of engine oil into the spark plug hole..

never pull the starter rope on the engine when the spark plug is removed unless

the spark plug hole is covered. Fuel vapor from the hole can ignite by a spark.

7.Place a rag over the spark plug hole and slowly pull the starter rope several times to distribute the oil..

9

www.chpower.com