Operating Instructions

Operating Instructions (Continued)

Adjusting the Fastener

Penetration

The tool is equipped with an adjustable depth of drive feature.. This allows the user to determine how deep a fastener will be driven into the work surface..

1.Adjust operating pressure so fasteners are driven consistently.. Do not exceed 100 psi..

2.To drive the fastener shallower, turn the wheel (C) to right to the extent desired..

3.To sink a fastener deeper, turn the wheel (C) to left to the extent desired..

(C)

4.Make sure trigger and work contact element

(WCE) move freely up

Movement

and down without

 

binding or sticking

 

after each adjustment..

 

Adjusting The Direction Of The Exhaust

The tool is equipped with an adjustable direction

Clearing A Jam From The Tool

1. Disconnect the air supply from the tool..

2. Remove all nails from the magazine (see "Loading/ Unloading

The Nailer").. Failure to do so will cause the

nails to eject from the front of the nailer..

3. Undo latch by pulling out and down.. The wire latch will disengage from the hooks on the nose..

4. The door can now be rotated, exposing the jammed fastener..

5. Remove the jammed fastener, using pliers or a screwdriver if required..

6. Rotate door back into the closed position..

7. Extend the wire latch and place over the hooks on the nose..

8. Close the latch by pushing the latch up and in until the latch snaps into place..

9. Make sure the trigger and work contact element (WCE) move

User-Maintenance

Instructions

Technical Service

Please call our Tool Hotline at 1-800- 543-6400 with any questions regarding the operation or repair of this tool or for additional copies of this manual..

Fastener And Replacement Parts

Use only genuine Campbell Hausfeld

18 gauge fasteners (or equivalent - see Fastener Interchange Information). Tool performance, safety and durability could be reduced if improper fasteners are used. When ordering replacement parts or fasteners, specify by part number.

Tool Repair

Only qualified personnel should repair the tool and they should use genuine Campbell Hausfeld replacement parts and accessories, or parts and accessories which perform equivalently..

Assembly Procedure For Seals

When repairing a tool, the internal parts must be cleaned and lubricated.. Parker O-lube or equivalent must be used on all o-rings.. Each o-ring must be coated with O-lube before assembling.. A small amount of oil must be used on all moving surfaces and pivots.. After reassembling, a few drops of 30W non-detergent oil or equivalent, must be added through the air line before testing..

Storage

The stapler should be stored in a cool dry place..

exhaust deflector.. This is intended to

Rotate

freely up and down without sticking or binding..

allow the user to change the direction of the exhaust.. Simply twist the deflector to any direction desired..

www.chpower.com

6