Operating Instructions and Parts Manual | CHN71600 |
|
|
Loading / Unloading The Stapler
Choose which type of fastener you want to use for you project. Additional fasteners can be found at major home centers.
Loading the Stapler
Always disconnect the tool from the air supply before loading/unloading fasteners.
1. Press down on latch and pull back on the magazine cover.
2. Insert a stick of Campbell Hausfeld staples or equivalent (see “Fasteners” section) into the magazine. Make sure the staples are not dirty or damaged.
3. Push the magazine cover forward until the latch catches.
Unloading the Stapler
Always disconnect the tool from the air supply before loading/unloading fasteners.
1.Press down on latch and pull back on the magazine cover.
2.Remove fasteners.
3.Push the magazine cover forward until the latch catches.
Figure 7 - Loading the stapler
Operation
Operational Mode
Always know the operational mode of the tool before using. Failure to know the operational mode could result in death or serious personal
injury.
Trigger only mode (with trigger lock)
The tool is a
After verifying there are no fasteners in the tool, safety check the operation of the activated trigger lock to prevent the tool from firing a fastener before storage. Always disconnect from compressed air when not in use.
UnlockLock
Figura 8
10www.chpower.com