Operating Instructions and Parts Manual | CHN71600 |
|
|
Storage
The stapler should be stored in a cool dry location.
Maintenance
Clearing A Jam From The Stapler
1.Disconnect stapler from air supply.
2.Remove all fasteners from the magazine (see Loading/ Unloading). Failure to do so may cause the fasteners to eject from the front of the stapler.
3.Press magazine latch (see Loading / Unloading the Stapler).
4.Open the magazine, exposing the jammed fastener.
5.Remove the jammed fastener, using pliers or a screwdriver if required.
6.Load with staples.
7.Make sure the trigger moves freely without sticking or binding.
Stapler Repair
Only qualified personnel should repair the tool and they should use genuine Campbell Hausfeld replacement parts and accessories, or parts and accessories which perform equivalently.
Replacement Parts
Use only genuine Campbell Hausfeld service parts.Tool performance, safety and durability could be reduced if improper parts are used.When
ordering replacement parts, specify by part number.
Assembly Procedure For Seals
When repairing a stapler, the internal parts must be cleaned and lubricated. Parker
Technical Service
For information regarding the operation or repair of this product, please call
Fastener Interchange Information
Fasteners used in the Campbell Hausfeld CHN71600 3/8 inch Stapler include:
•Arrow® T50® staples or any equivalent fastener with the approximate dimensions illustrated in Figure 10
Figure 9
10.7mm
inch 9/16 - inch 1/4 mm14 - mm6
1.3mm
9.3mm
mm7.0
Figure 10
www.chpower.com 11