Campbell Hausfeld JB006750 Technical Support, Fastener And Replacement Parts, Nailer Repair, Assembly Procedure For Seals

Operating Instructions	Model JB006750

Operating The Nailer

(Continued)

3.Insert a stick of

Campbell Hausfeld nails

or equivalent (see Fastener

Section) into the magazine. Make sure the pointed ends of the nails are resting on the bottom ledge of the magazine when loading. Make sure the nails are not dirty or damaged.

4.Push the maga-

zine cover forward until the latch catches.

5.Always unload all fasteners before removing tool from service. Unloading is the reverse of loading, except always disconnect the air hose before unloading.

ADJUSTING THE NAIL PENETRATION

The tool is equipped with an adjustable depth of drive feature. This allows the user to determine how deep a fastener will be driven into the work surface.

1.Adjust operating pressure so nails are driven consistently. Do not exceed 110 psi.

2.To drive the nail shallower, turn the wheel (C) to left to the extent desired.

(C)

4.Make sure trigger and work contact ele-

ment (WCE) move freely up and down without binding or sticking after each adjustment.

ADJUSTING THE DIRECTION OF THE EXHAUST

The tool is
equipped with an
adjustable direc-
tion exhaust	Rotate

deflector. This is intended to allow the user to change the direction of the exhaust. Simply twist the deflector to any direction desired.

CLEARING A JAM FROM THE NAILER

1.Disconnect the air supply from

the nailer.

2. Remove all

nails from the magazine (see Loading/ Unloading).

Failure to do so will cause the nails to eject from the front of the tool.

3. Undo latch by pulling out and down. The wire latch will disengage from the hooks on the nose.

4.The door can now be rotat- ed, exposing the jammed fastener.

5.Remove the jammed fasten- er, using pliers or a screwdriver if required.

7.Extend the wire latch and place over the hooks on the nose.

8.Close the latch

by pushing the latch up and in until the latch snaps into place.

	9. Make sure the
	trigger and
	work contact
	element (WCE)	movement
	move freely up	movement
	move freely up

and down without sticking or binding.

Technical Support

Please call our Nailer Hotline at 1-800- 543-6400 with any questions regarding the operation or repair of this nailer or for additional copies of this manual.

Fastener And Replacement Parts

Use only genuine Campbell Hausfeld 16 gauge fasteners (or equivalent) - see Fastener Interchange Information. Tool perfor- mance, safety and durability could be reduced if improper fasteners are used. When ordering replacement parts or fasteners, specify by part number.

Nailer Repair

Only qualified personnel should repair the tool and they should use genuine Campbell Hausfeld replacement parts and accessories, or parts and accessories which perform equivalently.

Assembly Procedure For Seals

When repairing a nailer, the internal parts must be cleaned and lubricated. Parker O-lube or equivalent must be used on all o-rings. Each o-ring must be coated with O-lube before assembling. A small amount of oil must be used on

		6 Rotate door
	3. To sink a nail deeper, turn the wheel	back into the
	3. To sink a nail deeper, turn the wheel	closed position.
	(C) to right to the extent desired.	closed position.
	(C) to right to the extent desired.

all moving surfaces and pivots. After reassembling, a few drops of 30W non- detergent oil or equivalent, must be added through the air line before testing.