Assembly Instructions and Parts List

PW1345B

Power Cord

1.Plug the power cord into a ground- ed 120V outlet and press the reset button as shown in figure 3.

2.THIS MUST BE DONE EACH TIME THE UNIT IS PLUGGED IN AN OUTLET.

Reset

Figure 3 - Grounded plug/reset button

! IMPORTANT !

This pressure washer is equipped with a microswitch sensitive to water flow. This Instant Start/Stop switch (ISS) senses water flow in the pump. When the trigger is released, water stops flowing through the pump. The ISS then automatically turns the motor off to protect pump from overheat- ing.

OPERATION

1.Turn the “ON/OFF” switch to “ON”.

2.Pull trigger on gun to begin spray- ing water.

3.Release trigger. The pressure wash- er motor will stop running.

4.To spray again, pull trigger and motor and pump will restart.

Note: Occasionally the motor may run for a short time to bring fresh, cool water into the pump even if trig- ger is released. This is part of normal operation and will not damage the unit.

Always turn the

!CAUTION “ON/OFF” switch to “OFF” then trigger gun to release hose pressure before unplugging power cord.

Risk of Injection.

!WARNING Unit will start spray- ing when trigger is squeezed if on/off switch is in “ON” position. Always point gun in safe direc- tion.

Call 1-800-330-0712 for Technical Service

www.chpower.com

2

Page 2
Image 2
Campbell Hausfeld PW1345B specifications Power Cord, Operation