Operating Instructions and Parts List | PW1550 |
PW1550
! IMPORTANT !
This pressure washer is equipped with a microswitch sensitive to water flow. This Instant Start/Stop switch (ISS) senses water flow in the pump. When the trig- ger is released, water stops flowing through the pump. The ISS then auto- matically turns the motor off to protect pump from overheating.
OPERATION
1.Pull trigger on gun.
2.Turn the “ON/OFF” switch to “ON”.
3.Release trigger. The pressure washer motor will stop running.
4.To spray again, pull trigger and motor and pump will restart.
Note: Occasionally the motor may run for a short time to bring fresh, cool water into the pump even if trigger is released. This is part of normal opera- tion and will not damage the unit.
Always turn the 
“ON/OFF” switch to “OFF” then trigger gun to release hose pressure before unplugging power cord.
Risk of equipment damage. Always
make sure the “ON/OFF” switch on the unit is “OFF” and unit is unplugged prior to storage.
Risk of Injection. Unit will start
spraying when trigger is squeezed if ON/OFF switch is in “ON” position. Always point gun in safe direction.
Call
Important Safety Instructions
SAVE THESE INSTRUCTIONS
When using this product, basic precautions should always be followed, including the following:
1.Read all instructions before using the product.
2.ALWAYS disconnect power before disassembling or repairing the unit.
3.Follow all safety codes as well as the Occupational Safety and Health Act (OSHA).
4.Ensure safety devices are operating properly before each use. DO NOT remove or modify any part of the gun or unit.
5.Know how to stop this product and bleed pressure quickly. Be thoroughly familiar with the controls.
6.Stay alert – watch what you are doing.
7.Do not operate the product when fatigued or under the influence of alcohol or drugs.
8.Keep operation area clear of all persons.
9.Do not overreach or stand on unstable support. Keep good footing and balance at all times.
10.Follow the maintenance instructions specified in the manual.
11.This product is provided with a ground fault circuit interrupter, GFCI, be sure to inspect cord and GFCI prior to use. Any repair or replacement of the power cord must be performed by a qualified (licensed or certified) electrical technician.
12.Never use an extension cord with this product.
Notes Notas
www.chpower.com
2 | 35 |
