Operating Instructions
8. Protect air lines from damage or | Operation | back and lock into place.. | ||||||||
|
|
| ||||||||
| puncture.. | filling the canister | 2. Insert the bulk fill valve into the | |||||||
9. Never point an air tool at oneself or | ||||||||||
filler pump socket.. | ||||||||||
|
|
| ||||||||
| any other person.. Serious injury | (There are three methods to load the | 3. Fill the container tube and | |||||||
| could occur.. | air grease gun..) | ||||||||
| disconnect the grease gun from the | |||||||||
10. Check air hoses for weak or worn | MEthod 1 - Cartridge (See Figure 1) | |||||||||
filler.. | ||||||||||
| condition before each use.. Make |
|
|
| ||||||
|
|
|
| 4. Press the plunger release to release | ||||||
| sure all connections are secure.. |
|
|
| ||||||
|
|
|
| the plunger handle rod and push | ||||||
|
|
| Release all |
|
|
|
|
| ||
|
|
|
|
|
|
|
| the plunger handle back into the | ||
|
|
| pressure |
|
|
|
|
| container tube.. | |
|
|
|
|
|
| |||||
from the system before |
|
|
|
|
| |||||
|
|
|
|
|
| |||||
attempting to install, service, |
|
|
|
|
| Method 3 - Bulk Filling | ||||
|
|
|
|
| ||||||
relocate or perform any |
|
|
|
| ||||||
| Figure 1 - Cartridge Replacement | (See Figure 3) | ||||||||
maintenance. |
|
|
| |||||||
|
|
| ||||||||
|
|
|
| |||||||
11.Keep all nuts, bolts and screws tight and ensure equipment is in safe working condition..
12.Do not put hands near or under moving parts..
Excessive exposure to vibration,
working in awkward positions and repetitive work motions can cause injury to hands and arms. Stop using any tool if discomfort, numbness, tingling or pain occur and consult a physician.
Never carry a tool by the hose or pull
the hose to move the tool or a compressor. Keep hoses away from heat, oil and sharp edges. Replace any hose that is damaged, weak or worn.
Assembly
System setup
PLEASE REFER TO AIR TOOL AND SPRAY GUN
Using fittings or air hoses which are too small can create a pressure drop which will result in a loss of power in the tool..
1.Unscrew the gun head from the container tube..
2.Pull the plunger handle completely back and lock into place..
3.Insert the open end of a grease cartridge into the container tube and completely push in the cartridge..
4.Remove the seal from the cartridge..
5.Screw the gun head and container tube back together..
6.Press the plunger release to release the plunger handle rod and push the plunger handle back into the container tube..
Method 2 - Filler Pump
(See Figure 2)
Figure 2 - Filler Pump Method
1. Pull the plunger handle completely
Figure 3 - Bulk Filling
1.Unscrew the gun head from the container tube..
2.Pull the plunger handle back approximately 2 to 3 inches and fill this section of the container tube.. Repeat this process until the entire container tube is filled.. Be careful to pack without air pockets..
3.Screw the gun head and container tube back together..
4.Press the plunger release to release the plunger handle rod and push the plunger handle back into the container tube..
www.chpower.com
2