PROGRAMME SELECTION AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)Programme settings
■Open the door and place the dirty dishes inside the appliance.
■Press the "ON/OFF" button 
.
■After pressing the "ON/OFF" button, the programme indicator lights will flash.
■Choose a programme by pressing the "PROGRAMME SELECTION" button (PR.).
The selected programme indicator light will come on.
When the "COLD RINSE" programme is selected, 2 indicator lights will come on.
■Close the door (after an audible signal has sounded, the programme will start automatically).
Programme interruption
Opening the door when a programme is running is not recommended especially during the main wash and final hot rinse phases. However, if the door is opened while a programme is running (for example, to add dishes) the machine stops automatically.
Close the door, without pressing any buttons. The cycle will start from where it left off.
WARNING!
If you open the door during the drying cycle, an audible audio signal advises you that the drying cycle has not yet finished.
Changing a running programme
Proceed as follows to change or cancel a running program:
■ Hold down the "PROGRAMME SELECTION" button until the programme indicator lights will start to flash.
■The running programme will be cancelled.
■At this point a new programme can be set.
WARNING!
Before starting a new programme, you should check that there is still detergent in the dispenser.
If necessary, top up the dispenser.If there is any break in the power supply while the dishwasher is operating, a special memory stores the selected programme and, when the power is restored, it continues where it left off.
Programme end
A 5 seconds alarm will sound (if not muted) 3 times at 30 seconds intervals to signal that the programme has ended.
The programme indicator lights will start to flash.
Dishes can now be removed and the dishwasher turned off by pressing the "ON/OFF" button or dishes can be loaded for new cycle.
Alarm mute
The alarm for the programme end may be muted as follows:IMPORTANT
The dishwasher must be ALWAYS off before start this procedure.
1.Press the "ON/OFF" button.
2.Wait for the programme indicator lights to start flashing.
3.WITHIN 2 MINUTES of switching the machine on, hold down the "PROGRAMME SELECTION" button for at least 30 seconds (an intermittent acoustic signal will sound).
4.When the 2 indicator lights on the left will come on (to indicate that the alarm is on) and the acoustic signal will stop to sound, release the button.
5.Press the "PROGRAMME SELECTION" button again.The first 2 indicator lights from the left will go off, while the other 2 indicator lights will come on to indicate that the alarm has been deactivated.
6.Wait for the alarm to sound to indicate that the settings were saved (the programme indicator lights will return to flash).
7.To turn the alarm on again, follow the same procedure.
WARNING!
If any problem occurs, turn the dishwasher off by pressing the "ON/OFF" button and start the procedure again from the beginning.
Fault signals
If malfunctions or faults occur when a programme is running the indicator light that corresponds to the selected cycle (2 indicator lights for the "COLD RINSE" programme) will flash rapidly and the alarm sounds.
In this event, turn the dishwasher off by pressing the "ON/OFF" button.
After checking to make sure the water inlet hose tap is open, that the drain hose is not bent and that the siphon or
filters are not clogged, set the selected programme again.If the anomaly persists, contact Customer Service Department.
IMPORTANT
This dishwasher is equipped with an
WARNING!
To ensure the correct operation of the
100 | 101 |