6Establish the connection.

zzOn the access point, hold down the WPS connection button for a few seconds.

zzOn the camera, press the <m> button.

XXThe camera will connect to the access point.

XXA list of computers connected to the access point will appear in the [Select a Device] screen.

7Choose a computer to connect to.

zzPress the <o><p> buttons to choose the computer name, and then press the <m> button.

zzWhen using a Macintosh computer, see Using CameraWindow to Transfer Images to a Computer (=98).

8Install a driver (first Windows connection only).

zzWhen the screen at left is displayed, click the Start menu on the computer, click [Control Panel], and then click [Add a device].

zzDouble click the connected camera icon. XXDriver installation will begin.

XXAfter driver installation is complete, and the camera and computer connection is enabled, the AutoPlay screen will be displayed. Nothing will be displayed on the camera screen.

zzProceed to Using CameraWindow to Transfer Images to a Computer (=98).

•When you are in the vicinity of an access point that you have previously connected to, the camera will automatically connect to it in step 3. To change access points, select [Switch Network] from the screen that will be displayed when the connection is being established, and follow steps 4 – 5 in “Adding a Computer” (=96).

•You can connect to computers that you have already connected to by choosing them on the [Select a Device] screen in step 3.

•If you chose [ IN Method] in step 5, a PIN code will be displayed on the screen. Be sure to set this code in the access point. Choose a device in the [Select a Device] screen. For further details, refer to the user guide included with your access point.

•To add multiple computers, repeat the above procedures starting from step 1.

•To disconnect from the camera, turn off the camera.

•After you have accessed the Wi-Fi menu once, you can access it again by pressing the <o> button. The recent target device is listed first, so you can easily connect again by pressing the <o><p> buttons to choose it. To add a new device, display the device selection screen by pressing the <q><r> buttons, and then configure the setting.

If you prefer not to display recent target devices, press the <n> button, and on the [3] tab, choose [Wi-Fi Settings] > [Target History] > [Off].

Cover

Preliminary Notes and

Legal Information

Contents:

Basic Operations

Basic Guide

Advanced Guide

1

Camera Basics

2

ModeSmart Auto

3

Other Shooting

Modes

4

P Mode

5 Playback Mode

6

Wi-Fi Functions

7

Setting Menu

8

Accessories

9

Appendix

Index

97