drilled. In future fills it’ll be necessary to clear the hole each time over the reservoir in order for the needle to enter. Generally that will mean using the drill again as the glue will go down into the hole a bit.
If you don’t get a good seal with the glue over the fill hole, ink will immediately begin to run out of the exit hole on the bottom. I tried using electrical tape as others have suggested, and even though it was applied very tightly, it didn’t seal. The glue does, and is easy to use. Only problem with it is the need to clear the fill hole each time you want to refill. The tape would have been more convenient, but that’s the way it goes!!!
Caveat:
I haven’t tried this with any other Canon printer so can’t vouch for this method with any other than the i860. Seems that it ought to work on any with this tank system though, but you’ll have to try for yourselves.
Good
Ted Johnson
