Canon iR3530, ir3570, ir4570, iR2870, iR2270, iR2230 manual Abc, Menu Offset X/Offset Y

2

Menu

■Offset X/Offset Y

-50.0 to +50.0 mm (in increments of 0.5 mm); 0.0* mm

This setting sets the offset position in millimeters. The settings can be set between -50.0 mm (-2.00 inch) and +50.0 mm (+2.00 inch) in increments of 0.5 mm (0.01 inch).

The print position is adjusted in the vertical or horizontal direction to the value specified in the setting value.

You can increase or decrease the setting in increments of 0.5 mm (0.01 inch) to adjust the print position, as described below.

Offset X: Increasing the setting value moves the image in the rightward X direction on the paper. Decreasing the setting value moves the image in the leftward X direction on the paper.

Offset Y: Increasing the setting value moves the image in the downward Y direction on the paper. Decreasing the setting value moves the image in the upward Y direction on the paper.

Area adjusted using

X-Adjustment

Printer Settings

ABC DEF

Front Back

Adjust using X/Y-Adjustment

	X	[+]
using	Y
adjusted Adjustment	[+]	ABC
-
Area Y
		Front

X

Y

DEF

Back

Part of the original margin

IMPORTANT

Please note that if the print position is adjusted to place print data outside the valid print area, the portion outside the valid print area is not printed.

NOTE

•If this setting is used in combination with the Margin setting, the values of the two settings are added together.

•Pressing [ ] increases the setting value by 0.5 mm (0.01 inch) each time the key is pressed.

Pressing [ ] decreases the value by 0.5 mm (0.01 inch) each time. Holding down either [ ]

or [ ] continuously speeds up the value alteration.

2-12Settings Menu