4
CAUTION:
TOREDUCETHERISKOFELECTRIC
SHOCK,DONOTREMOVECOVER(OR
BACK).NOUSER-SERVICEABLEPARTS
INSIDEEXCEPTLAMPREPLACEMENT.
REFERSERVICINGTOQUALIFIED
SERVICEPERSONNEL.
THISSYMBOLINDICATES
THATDANGEROUSVOLTAGE
CONSTITUTINGARISKOFELECTRIC
SHOCKISPRESENTWITHINTHIS
UNIT.
THISSYMBOLINDICATESTHAT
THEREAREIMPORTANTOPERATING
ANDMAINTENANCEINSTRUCTIONS
INTHEUSER'SMANUALWITHTHIS
UNIT.
CAUTION
RISKOFELECTRICSHOCK
DONOTOPEN
Before installing and operating this projector, read
this manual thoroughly.
This projector provides many convenient features
and functions.
Operating the projector properly enables you to
manage those features and maintains it in good
condition for many years to come. Improper
operation may result in not only shortening the
product-life, but also malfunctions, fire hazard, or
other accidents.
If your projector seems to operate improperly,
read this manual again, check operations and
cable connections and try the solutions in the
“Troubleshooting” section on pages 65-67 of this
manual. If the problem still persists, contact the
dealer where you purchased the projector or the
service center.
SafetyPrecaution
DONOTSETTHEPROjECTORINGREASY,
WET,ORSMOKYCONDITIONSSUCHASINA
KITCHENTOPREVENTABREAKDOWNOR
ADISASTER.IFTHEPROjECTORCOMESIN
CONTACTWITHOILORCHEMICALS,ITMAY
bECOME DETERIORATED.
READANDKEEPTHISUSER'SMANUALFOR
LATERUSE.
WARNING:
THISAPPARATUSMUSTBEEARTHED.
TOREDUCETHERISKOFFIREOR
ELECTRICSHOCK,DONOTEXPOSE
THISAPPLIANCETORAINORMOISTURE.
– This projector produces intense light from the
projection lens. Do not stare directly into the
lens, otherwise eye damage could result. Be
especially careful that children do not stare
directly into the beam.
– Install the projector in a proper position.
Improper positioning may reduce the lamp life
and result in severe accident or fire hazard.
– Allowing the proper amount of space on the
top, sides, and rear of the projector cabinet is
critical for proper air circulation and cooling of
the unit. The dimension shown here indicate the
minimum space required.
If the projector is to be built into a compartment
or similarly enclosed, these minimum distances
must be maintained.
– Do not cover the ventilation slot on the projector.
Heat build-up can reduce the service life of your
projector, and can also be dangerous.
– If the projector is unused for an extended time,
unplug the projector from the power outlet.
– Do not project the same image for a long time.
The afterimage may remain on the LCD panels
by the characteristic of panel.
SIDE and TOP REAR
0.7’(20cm)
1.5’(50cm) 3’(1m)
20cm
50cm 1m
1.5’(50cm)
50cm
CAUTION
Not for use in a computer room as defined in
the Standard for the Protection of Electronic
Computer/Data Processing Equipment, ANSI/
NFPA 75.