Setting
USB
The Projector has a USB port for interactive operation between the projector and computers. Set the mode by following the steps below.
Wireless Mouse mode
Select “ ” when controlling a computer with the remote control unit of this projector.
Projector mode:
“” Not used.
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not used for a certain period.
If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with “No signal” appears. It starts the countdown until the lamp is turned off. The countdown time can be set between 1 and 30 minutes.
Use the Point 7 8 buttons to set the countdown timer.
Select one of the following options:
Ready . . | When the lamp has been fully cooled down, the |
| POWER indicator starts blinking. In this condition, |
| the projection lamp is turned on if the input signal |
| is reconnected or any button on the side control or |
| remote control unit is pressed . |
Shutdown . | When the lamp has been fully cooled down, the |
| power is turned off. |
Off . . . | Power Management function is off. |
✔Note:
• Factory default is “Ready: 5 min.”
On start
When this function is set to “On,” the projector will be automatically turned on just by connecting the AC power cord to the wall outlet.
✔Note:
•Be sure to turn off the projector properly (see “Turning Off the Projector” on page 24). If the projector is turned off in the incorrect sequence, the On start function does not work properly.
Pointer
You can emphasize a part of the projected image with this function.
Use the Point 7 8 buttons to select a pattern of the Pointer (Arrow, Cross, or Dot) (P. 30)
✔Note:
•The Point ed7 8 buttons and OK button are invalid when the Pointer function is operating.
Power management
Time left before the lamp is off
Press the OK button at Power management and the dialog box appears. Use the Point 7 8 buttons to choose one of the three options.
Press the Point d button to select the timer, and then use the Point 7 8 buttons to set the timer
52
