Setting
Logo
This function allows you to customize the screen logo with Logo select, Capture, and Logo PIN code lock functions.
✔Note:
•When “On” is selected in the Logo PIN code lock function, Logo select and Capture functions cannot be selected.
Logo select
This function decides on the
User . . Show the image you captured. Default . Show the
Off . . Show the countdown display only.
Logo
Capture
This function enables you to capture an image being projected to use it for a
Select Capture and press the OK button.
A confirmation box appears and select [Yes] to capture the projected image.
After capturing the projected image, go to the Logo select function and set it to “User”.Then the captured image will be displayed the next time you turn on the projector.
Set the red frame pointer to the item and press the OK button.
Select [Yes] to stop capturing.
Select [Yes] to capture the projected image.
To cancel the Capture function, select [No].
✔Note:
•Before capturing an image, select “Standard” in the Image Select Menu to capture a proper image (pp. 38, 42). Adjusted image on the screen cannot be captured.
•A signal from a computer can be captured up to XGA (1024 X 768).
•Certain signals may not be captured properly.
•When capturing the image that has been adjusted by the Keystone function, the adjusted data is automatically reset and the projector captures an image without keystone correction.
•When starting to capture a new image, the previously stored image is cleared even if you cancel the capturing.
•Once you exit the Logo Menu after setting the Logo lock to "On," you are required to enter the PIN code every attempting to change the Logo setting.
•User cannot be selected when the image is not captured.
Capture
49
