1 Unpack the Printer
1Carefully remove all items from the box.
Start Here
Easy Setup Instructions2 Prepare the Printer | 3 Prepare the Printhead | 4 Install Printhead |
1 Remove the shipping tape from the front, | 1 Remove the printhead from its package. | 1 Ensure that the blue lock lever is raised. |
sides and inside of the printer. |
|
|
S200
5 Connect the Printer
To Your Computer
1Unplug the power cord from the back of the printer.
IMPORTANT: Be sure printer is unplugged before continuing, or the computer will attempt to install the printer driver before the printer is ready.
S200 Series
Color Bubble Jet Printer
Paper Rest
Output Tray
Documentation
and Software Kit
Printhead (ink tanks are included)
Shipping Tape
2Plug the power cord into the back of the printer and connect the other end to a power outlet.
The printer automatically turns on when the printer is plugged in.
3Open the front cover. The printhead holder automatically moves to the center.
Serial number
2 Gently slide the printhead into the holder until it is securely seated.
Do not press it down.
2 Remove the protective cap and tape from the printhead.
3 Lower the lock lever until it locks into place.
NOTE: Do not touch the electrical contacts.
4 Close the front cover and attach the paper rest and output tray.
Electrical contacts
2Turn your computer off.
3Connect one end of a USB cable (not included) to the computer, the other to the printer.
USB Port
USB Port
USB Cable
Power Cord
4Write down the serial number located to the right of the printhead. You will need this later to register the product.
Continue with Step 6 on side two.
5Place a stack of blank paper (up to 50 sheets) in the paper rest.