31
3
4
The VB150s connected to the network are
automatically detected and their MAC
address, the currently set IP address and
the model name are displayed. The factory
default setting is:
IP address : 192.168.100.1.
The MAC address for the VB150 can be
found on the warranty card or on the seal
attached on the bottom of the unit.
Note that VBSetup.exe cannot be used
across segments.
If a multiple number of VB150s are
connected to the network, all of them are
displayed. Select a MAC address to be
used for initial setup by clicking on it, then
click the “Initial Setup...” button.
When the “Initial Setup” dialog box appears,
enter the user name and password set as
the factory defaults.
User Name : root
Password : VB150
Then enter the IP address and subnet mask
you want to set for the VB150. If you want
to specify a default gateway address,
enable the [Set the default route to
Ethernet] check box and then enter the
default gateway address. Although the time
zone and video signal can also be specified
here, there is basically no need to change
the time zone setting. Then click the OK
button.
Click to select