Capresso 276, 275 operating instructions Chlorine Reducing Setting / Extended Boil Setting

Please note: if the selected heating temperature is set to 212ºF or 200ºF degrees the warm-keeping temperature cannot be set higher than 190ºF.

After the selected heating temperature is reached, the display will now change to the preselected warm-keeping temperature. The warm-keeping symbol and the warm-keeping temperature are displayed. Once the water cools to approx. 10ºF below the pre-set warm-keeping temperature, the heater will automatically start re-warming the water to the pre-set temperature. During this time the warm-keeping symbol will be blinking. The kettle will keep the selected temperature for up to 40 minutes. After 40 minutes the warm-keeping symbol stops blinking indicating that the heating element has shut off.

Please note: once you remove the kettle from the power base, all pre-sets are cancelled.

Tip: If you want to pour water immediately after brewing and then keep the rest at a certain temperature, proceed as follows:

•Follow the instructions under chapter 1 or 4.

•Pour the desired amount of water.

•Replace the kettle.

•Select the brewing temperature by pushing the arrow buttons.

•Push the program button once to show the warm-keeping display

000ºF. Use the arrow buttons to select the desired warm-keeping temperature.

•Push the On/Off button.

The kettle is now on. Depending on the temperature of the water it will either re-heat the water immediately or later.

6. CHLORINE REDUCING SETTING / EXTENDED BOIL SETTING

If you boil the water in the default setting, the kettle will shut off 3 seconds after the sensor registered the boiling temperature. You can prolong the actual boiling action as follows:

•Set the Chlorine symbol to “CL”, this will add three extra seconds to the boiling of the water.

•Change the Timer Setting from 003 (seconds) to any duration up to 20 seconds (020).

•Prepare the kettle as explained in chapter 1.

•Before you push the On/Off button, push the program button twice, the Chlorine symbol appears (Fig. 3c).

•Push either arrow button once, the display shows “CL”.

•Push the program button again. The display shows the timer symbol and 003 (Fig. 3d).

9.