Carrier 260L Maintenance, Lamp Replacement, Condensate Removal, Condenser, Cabinet Exterior

Models: 1300L 260L

1 16
Download 16 pages 13.76 Kb
Page 14
Image 14
MAINTENANCE

MAINTENANCE

LAMP REPLACEMENT

Before proceeding with replacement, disconnect electrical service. Failure to unplug unit could result in serious personal injury or death.

Remove lamp by rotating lamp 90 degrees to align lamp pins with holder slots. Refer to Bi-Pin Fluores- cent lamp Installation/Verification section on page 6.

CONDENSATE REMOVAL

The evaporator drain pan is located in the base of the cartridge. In general, the condensate disposal system is maintenance free.

CONDENSER

The condenser should be inspected periodically for accumulation of debris, which should be removed. A vacuum cleaner or brush can be used to remove debris.

CABINET EXTERIOR

Cabinets should be cleaned with a solution of mild soap and water or mild household cleaner. Do not use caustic soap or abrasive cleaners, since these might damage the cabinet finish. If stainless steel surface becomes discolored, scrub by rubbing only in direction of the finish grain. Do not use steel wool or rusting may occur. Refer to Table 4.

INTERIOR SURFACE

The inside of the cabinet is coated with baked-on epoxy. To clean, use a mild soap and water solution or mild household cleaner.

14

Page 14
Image 14
Carrier 260L, 1300L Maintenance, Lamp Replacement, Condensate Removal, Condenser, Cabinet Exterior, Interior Surface