OWarmer & Cooler Commands in Auto Changeover
If the thermostat is configured to Auto Heat/Cool changeover:
COOLER button press while in Auto or Off mode:
When the thermostat receives a Cooler command (button press) through the remote control and the air conditioner is not running, the set points will be lowered to start the air conditioning operation. If the air conditioner is running upon a Cooler button press, the set points will be lowered 2 degrees. The remote control receiver will allow up to 3 successive Cooler button presses. After the 3rd successive Cooler button press, the IR receiver will not accept an additional Cooler button press for 1 minute.
When the thermostat receives a Cooler command (button press) and the heater is running, the set points will be lowered so that the Heat set point is the same as the present room temperature which will then turn off the heater. The thermostat will not accept another Cooler button press for 10 seconds.
Page 7