Carrier instruction manual 58CMAMultipoise Oil Furnace, Table Of Contents, For Your Safety

58CMA Series 130 Multipoise Oil Furnace

Visit www.carrier.com

Installation, Start-up,

and Operating Instructions

NOTE: Read the entire instruction manual before starting the

installation.
This symbol → indicates a change since last issue.
TABLE OF CONTENTS
SAFETY CONSIDERATIONS	1
INTRODUCTION	2
LOCATION	3
General	3
Location Relative to Cooling Equipment	3
INSTALLATION	3
Air for Combustion and Ventilation	3
General	4
Unconfined Space	4
Confined Space	4
All Air from Inside the Structure	4
All Air from Outside of Structure	5
Duct Work Recommendations	5
Venting	5
Oil Burner	6
Oil Connections	6
Barometric Draft Control	6
Electrical Connections	6
Horizontal or Downflow Installation	7
Filters	7
START-UP, ADJUSTMENT, AND SAFETY CHECKOUT	7
Operational Checkout	7
Combustion Check	7
Fan Adjustment Check	10
Limit Control Check	11
For Year-Round Air Conditioning	11
Heating	11
Cooling	11
Constant Blower Switch	11
MAINTENANCE	11
General	11
Oil Burner	11
Heat Exchanger and Flue Pipe	11
Blower Removal	12
SAFETY CONSIDERATIONS

FOR YOUR SAFETY

DO NOT STORE OR USE GASOLINE OR OTHER

FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. DO NOT ATTEMPT TO START THE BURNER WHEN EXCESS OIL HAS ACCUMULATED, WHEN THE FURNACE IS FULL OF VAPOR, OR WHEN THE COMBUSTION CHAMBER IS VERY HOT.

A97247

Fig. 1—58CMA Multipoise Oil Furnace

For use with grade 1 or 2 Fuel Oil. Do not use Gasoline, Crankcase Oil, or any Oil containing Gasoline! Failure to follow this warning could lead to sooting, fire, explosion, and/or severe bodily harm.

Never burn garbage or paper in the heating system and never leave rags, paper, or any flammable items around the unit. Failure to follow this caution will result in minor unit or property damage.

These instructions are intended to be used by qualified personnel who have been trained in installing this type of furnace. Installation of this furnace by an unqualified person may lead to equipment damage and/or a hazardous condition which may lead to bodily harm.

All local and national code requirements governing installation of oil burning equipment, wiring, and flue connections must be followed. Some of the codes (issued by the Canadian Standards Association, the National Fire Protection Agency, and/or the American National Standards Institute) that may be applicable are:

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

Book	1	4	PC 101	Catalog No. 535–80076	Printed in U.S.A.	Form 58CMA-4SI	Pg 1	9-03	Replaces: 58CMA-3SI
Tab	6a	8a