SUGGESTION:Settingthethermostatbackfewdegrees andcompensatingforthedifferencewithwarmerclothing canmakebigdifferenceinyourfuelconsumptionThefew. degreesatthetopofyourthermostat"comfort level" are the
most costly degrees to obtain.
When the room temperature drops below the temperature selected
on the thermostat, the furnace will switch on automatically.
When the room temperature reaches the temperature selected on
the thermostat, the furnace will be switched off automatically.
Some thermostats have a FAN mode with 2 selections: AUTO
and ON. When set on AUTO, the furnace blower cycles on and
off. In the ON mode, the furnace blower runs continuously.
Continuous fan keeps the temperature level in your home more evenly balanced. It also permits the indoor air to be continuously
filtered. With the unique feature Fan On Plus"', the blower speed can be increased or decreased if desired due to change of seasons,
large gatherings in your home, etc. Simply change your FAN
from ON to OFF for 1 to 3 seconds (or AUTO depending on
your thermostat), and then return to ON. The blower will switch to the next higher speed. There are at least 3 speeds to choose from. If the blower is running on its highest speed, a request to change will direct the blower to return to its lowest speed.
If you own an Evolution Control, simply push the "fan" button to change the fan speed.
SHUTTING DOWN YOUR
FURNACE
c_ | • • | £AN: AUIO |
A92185
Fig. 17 - Turn Off Electrical Supply
A04150
Fig. 18 - Control Switch to OFF
5.Replace the main furnace door. (See Fig. 13.)
6.If the furnace is being shut down because of a malfunction, call your dealer as soon as possible.
UNIT AND PROPERTY DAMAGE
Failure to follow this caution may result in damage to the furnace and other property damage.
Furnace is not to be installed, operated, and then turned off
and left turned off in an unoccupied structure during winter.
(See "Heading South for the Winter" procedures in
maintenance section on page 12).
• | / |
A08013
Fig. 16 - Lowest Temperature Setting
Should you ever need to shut down your furnace for service or
maintenance, you will need to turn the furnace off. The following
procedures must be followed:
1.Set your room thermostat to the lowest temperature setting. (See Fig. 16.)
2.Turn off electrical supply to the furnace. (See Fig. 17.)
3.Remove main furnace door. (See Fig. 10.)
4.Turn the switch on the gas control to the OFF position. (See Fig. 18.)
PERFORMING ROUTINE
MAINTENANCE
NOTE: The qualified installer or agency must use only
Installing and servicing heating equipment can be hazardous due to gas and electrical components.
Only trained and qualified personnel should install, repair, or
service heating equipment. Untrained personnel can perform
basic maintenance functions such as cleaning and replacing air filters.
All other operations must be performed by trained and qualified
service agency personnel. Observe safety precautions in this manual, on tags, and on labels attached to the furnace, and other
safety precautions that may apply.
With proper maintenance and care. your furnace will operate
economically and dependably. Instructions for basic maintenance
are found on this and the following pages. However. before
beginning maintenance, follow these safety precautions:
