3
Models 750, 751, 754, 774, 794 Safety
050418
Section 3 Safety
Weat Taylor Company are concer ned about the safety
of the operator when he or she comes in contact with
the freezer and its parts. Taylor has gone to extreme
efforts to design and manufacture built-in safety
features to protect both you and the service technic ian.
As an example, warning labels have been attached to
thef reezer to further point out safet y precautions to the
operator.
IMPORTANT -- Failure to adhere to the
following safety precaut ions may result in severe
personal injury. Failure to comply with these
warnings may also damagethe machine and its
components. Component damage will result in
part replacement expense and service repair
expense.

To Operate Safely:

DO NOT operate the freezer without reading
this operator’s manual. Failure to follow this instruction
may result in equipment damage, poor freezer
performance, health hazards, or personal injury.
SDO NOT operate the freezer unless it is
properly grounded.
SDO NOT attempt any repairs unless the
main power supply to the freezer has been
disconnected.
SDO NOT operate the freezer with larger
fuses than specified on the freezer data
label.
Failure to follow these instructions may result in
electrocution or damage to the machine. Cont act your
local authorized Taylor Distributor for service.
DO NOT use a water jet to clean or r inse the
freezer. Failure to follow this instruct ion may result in
serious electrical shock.
SDO NOT allow untrained personnel to
operate this machine.
SDO NOT operate the freezer unless all
service panels and access doors are
restrained with screws.
SDO NOT remove the door, beater and
blades, or drive shaft unless all control
switches are in the OFF position.
SDO NOT put objects or fingers in door
spout.
Failure to follow these instructions may result in
contaminated product or severe personal injury to
fingers or hands from hazardous moving parts.
USE EXTREME CAUTION when removing
the beater assembly. The scraper blades are very
sharp and may cause injury.
This freezer must be placed on a level
surface. Failure to comply may result in personal injury
or equipment damage.
DO NOT obstruct air intake and discharge openings:
Counter Model: 6” (152 mm) minimum air space on
both sides and 0” on the rear.
Console Models:3” (76 mm) minimum air space on
all sides.
Failure to follow this instruct ion may cause poor
freezer performance and damage to the machine.
Thesef reezers are designed to operate indoors, under
normal ambient temperatures of 70_-- 7 5 _F
(21_-- 2 4 _C). The freezers have successfully
performed in high ambient temperatures of 104_F
(40_C) at reduced capacities.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.