Page 4 of 8 |
MOUNTING
Amplifier
The amplifier is waterproof and may be located under hood in the engine compartment or other areas. Allow clearance for wiring. Inspect behind mounting area for clearance. Use #8 screws (supplied loose) for mounting.
Speaker
The speaker is weather resistant and is intended to be mounted on the outside of the vehicle or under front hood. Mount the speaker facing forward and as far forward on the vehicle as possible to minimize sound exposure to occupants. Choose a location that minimizes obstructions in front of the speaker to maximize forward sound. Attach the speaker to a sturdy part of the vehicle to prevent vibration and possible damage. Attach the speaker angled slightly toward the road so the front openings will drain off any fluids. Cover openings of speaker while drilling any holes.
DO NOT get metal shavings inside the speaker.
Switch Panel
Mount the switch panel underneath the vehicle dash board using #8 screws (supplied loose). Locate the panel away from the driver’s or passenger’s legs. Allow clearance for wiring. Inspect behind mounting area for clearance. Make all electrical connections before final mounting.
ELECTRICAL CONNECTIONS
Amplifier
Electrical connections to the amplifier are made using butt splices (not supplied). The butt splices need to be waterproof when unit is mounted under hood or other weather susceptible areas. A label on the amplifier identifies each lead function. An
NOTE: Permanent disconnection of the vehicle horn is NOT recommended.
Switch Panel
Electrical connections to the switch panel are made using 3/16”
Wire Size and Termination - The diagram shows the minimum wire size used for each connec- tion, along with recommended lead color. If the wire is longer than 10 ft. use the next larger wire size. Use only high quality crimp connectors for installation on the vehicle.
02/05/10 | CP5061A |