Page 6 of 16 | SC-1002 / 1012 / 1022-10 14 Installation Instructions |
| MOUNTING (Main unit) | | | | | | | |
| The mounting bracket supplied can be installed above | | | | | | | |
| Lockwashers |
| or below the unit. Mounting bolts slide into channels |
| on each side of the case. Lockwashers should be | Nut | | | |
| used between the case and bracket as well as be- | | | | | | | |
| | | | | | | |
| tween the bracket and nut. Choose a mounting loca- | | | | | | | |
| tion convenient to the operator and away from any air | | | | | | | |
| bag deployment areas. Inspect behind mounting area | | | | | | | |
| | | | | | | |
| for clearance. Assure adequate ventilation to prevent | | | | | | | |
| overheating. Consider wire routing and access to | | | | | | | |
| connections. Install mounting bracket to vehicle using | Bolt |
| 1/4" hardware (not supplied). | | | | | | | |
Channel 
(from rear)
Bracket
SC-1012 Remote Panel: The remote panel of the SC-1012 is typically mounted underneath the vehicle dashboard using mounting hardware (not supplied). Mount the panel in a location away from the driver’s or passenger’s legs.
SC-1022 Hand Control: Choose a mounting location convenient to the operator and away from any air bag deployment areas. Consider cable routing to amplifier. Mount the hand control with supplied Hook and Loop tape (VELCRO). If the tape method is not preferred, the hand control may be mounted several ways. A Holster (CP5003) to hold the Hand Control or a Hanger and Holder to hold the Hand Control like a microphone (ED1865) are available accessories.
See PARTS and ACCESSORIES Section.
