Cary Audio Design MS-1

WELCOME

15. REPLACEMENT PARTS: When replacement parts are required, be sure the service technician has used

replacement parts specified by the manufacturer or those having the same characteristics as the original

parts. Unauthorized substitutions may result in fire, electric shock or other hazards.

16. SAFETY CHECK: Upon completion of any service or repairs to the unit, ask the service technician to

perform safety checks to ensure the unit is in proper operating condition.

17. IMPORTANT SAFETY NOTE:

• Before connecting a new product such as the Cary Audio Design MS-1 to your audio or home theater

system, turn off all other equipment (preferably unplugging them from the AC power source). Many

audio components feature automatic turn-on circuits that may activate during an installation, potentially

causing damage to electronic components or speakers. This type of damage is not covered by product

warranties, and Cary Audio Design specifically disclaims responsibility for any such damage.

• Power Cord: The removable power cord provided with your player was specifically

designed for use with this product, but other AC cords may be used. Consult your dealer

for advice on AC power cords and high quality wire in your system.

• AC Fuse: The fuse is located inside the chassis and is not user serviceable. If the unit does not power

up, contact an authorized service representative.

• Wiring: Cables running inside walls should have the appropriate markings to indicate compliance and

listing by the UL, CSA or other standards required by the UL, CSA, NEC, or your local building code.

Questions about cables inside of walls should be directed to a qualified custom installer, licensed

electrician, or low-voltage contractor.

18. RECORDING COPYRIGHT: Recording of copyrighted material for other than personal use is illegal

without permission of the copyright holder.

19. NOTE TO CATV SYSTEM INSTALLER: This reminder is provided to call the CATV system installer's

attention to article 820-40 of the NEC, ANSI/NFPA 70, which provides guidelines for proper grounding

and, in particular, specifies that the cable ground shall be connected to the grounding system of the building

as close to the point of cable entry as practical.

20. FCC INFORMATION FOR USER:

• CAUTION: Any changes or modifications not expressly approved by Cary

Audio Design could void the user's authority to operate the equipment.

• NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device pursuant to Part 15 of the FCC Rules.

• These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates and can radiate radio frequency energy, and if not installed and

used in accordance with the instructions it may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from where the receiver is

connected.

21. OUTDOOR ANTENNA INSTALLATION/SAFE ANTENNA AND CABLE CONNECTION:

• If an outside antenna or cable system is connected to the

equipment, be sure the antenna or cable system is grounded in

order to provide protection against built-up static charges and

voltage surges. Article 810 of the National Electrical Code,

ANSI/NFPA 70 (in Canada, Part 1 of the Canadian Electrical

Code) provides information regarding proper grounding of the

mast and supporting structure, grounding of the lead-in wire to an

antenna discharge unit, size of grounding conductors, location of

antenna discharge unit, connection to grounding electrodes and

requirements for the grounding electrode.

outside antenna system should be located well away from power lines,

electric light or power circuits and where it will never come into contact with these power sources if it should

happen to fall. When installing an outside antenna, take extreme care to avoid touching power lines, circuits and

other power sources as this could be fatal. Because of the hazards involved, antenna installation should be left to

a professional.