Operation Guide 2984

Using the Timer

The Timer Mode lets you set a start time of up to 100 hours, in 1-minute steps. The time counts down from there, and an alarm sounds for 10 seconds when the end of the countdown is reached. You can also use an Auto Repeat Timer that repeats the timer operation from the same start time up to eight times when the end of the countdown is

❚To set the timer start time
If a countdown is in progress, stop it before performing the following steps.

1. In the Timer Mode, hold down the B button for about one second until the hours digits of the start

5. When everything is the way you want, press the B button to exit the setting screen.

•

To specify a start time of 100 hours, set 0:00 00.

•

The watch automatically exits the start time setting screen if you do not perform any

reached.

• In the Timekeeping Mode, press the C button three times to enter the Timer Mode.

Button

time start to flash.

Hours

(Decrease)

operation for about two or three minutes.

• Start

• Stop

2. Use the D (+) and A (–) buttons to change the hours setting.

Minutes

Hour

•Pressing the D button while the countdown is stopped will reset the displayed time to the start time.

•Pressing the A button while a countdown is in progress will pause it. You can resume the countdown from the currently displayed time by pressing A again.

Current Time

Seconds

Button

•Reset

•Holding down either button changes the setting at high speed.

3. Press the C button to select the minutes setting.

This causes the minutes digits to flash.

4. Use the D (+) and A (–) buttons to change the minutes setting.

•Holding down either button changes the setting at high speed.

(Increase)

Minutes

(Decrease)

(Increase)

Selecting the Timer Type

•Repeat Timer

When Repeat Timer is selected, the timer stops and displays the start time when it reaches the end of the countdown.

•Auto Repeat Timer

When Auto Repeat Timer is selected, the timer restores the start time and counts down again when the end of a countdown is reached. The countdown is repeated up to eight times.

❚To select the timer type

In the Timer Mode, with the countdown stopped and the

Auto Repeat Timer Indicator

current start time on the display, hold down the D button for

 

about one second. This will toggle the timer type between

 

Repeat Timer and Auto Repeat Timer. The “

” indicator is

 

on the display while the Auto Repeat Timer is selected.

• Press the A button to stop the countdown and the D button to display the start time.

❚To stop the alarm beeper

Press any button.

4