Assembling the Stand 
3. Use the two screws I to secure the top left and right edges of the back panel C to the brackets 5 of side panels A and B.
•At location 6, slip the G clip onto to the I screw before installing the screw.
6. Place the piano onto the stand.
IMPORTANT!
• In order to ensure you do not get your fingers pinched |
between the piano and the stand, grasp the piano on its |
sides (not its ends) at the locations marked with stars () |
in the illustration. |
6
G
5
I
I
4.Next, secure the bottom of the back panel C with the six F screws.
B 
A
C
F
5. Adjust the height adjustment screw 7 to provide support so crosspiece D does not bow downwards when the pedals are pressed.
D7
IMPORTANT!
•Pressing the pedals without adjusting height adjustment screw 7 can result in damage to crosspiece D. Always make sure you adjust height adjustment screw 7 before operating the pedals.
At least 10cm
At least 10cm
9
•At this time the screws on the bottom of the piano 8 should hook into the cutouts in the stand brackets 9.
| Back of piano |
Bracket cutout |
|
9 | Stand side panel |
8