Operation Guide DQR-300U

A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the clock.

Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the illustration.

Alarm Off

 

Alarm On

Current time

 

Snooze on indicator

(Hour, minutes, seconds)

Day of the week

 

 

PM indicator

Alarm time

Alarm on

indicator

DATE (month - date)

Wave OK indicator

 

 

Antenna Icon

 

Current Temperature

Current Humidity

 

Upcomimg weather indicator

In locations subject to radio frequency interference, the product may malfunction and require you to reset the product.

GENERAL GUIDE

Main unit

1SNOOZE/LIGHT button

Press this button to illuminate the display for about four seconds.

Pressing this button while the alarm is sounding stops the alarm.

2Alarm Time Set buttons

Use these buttons to change the alarm time or current time setting.

3SET button

Use this button when setting the current time.

4WAVE button

Press this button to receive the time calibration signal and adjust timekeeping.

5Alarm Mode selector SNZ: Snooze alarm on ON: Alarm on

OFF: Alarm off

6RESET button

Press this button to reset the clock after replacing its batteries.

7MAX/MIN TEMP. button

Press this button to display the high and low temperature values.

8MAX/MIN HUMIDITY button

Press this button to display the high and low humidity values.

9CLEAR button

Press this button to clear the currently displayed high/low temperature or humidity.

0°C/ °F button

Press this button to toggle the temperature units between Celsius and Fahrenheit.

ARE-SYNC button

Press this button to re-synchronize the timing of the main unit and the sub-unit.

BSELECT button

Press this button to toggle the display between main unit (INDOOR) and sub-unit (OUTDOOR) data.

Sub-unit

CSELECT button

Press this button to toggle the display between the current temperature and humidity.

DRESET button

Press this button to reset the sub-unit after replacing its batteries.

ETEST button

This button is for testing the unit. Normally, you should not press it. If you do, be sure to press the RESET button (D) next.

F°C/ °F button

Press this button to toggle the temperature units between Celsius and Fahrenheit.

2