Casio DT-X11 Series manual Performing a Full Reset Initialization, To perform a full reset

Performing a Full Reset (Initialization)

Performing a full reset initializes memory. This means that all data stored in the memory (RAM) is deleted and all the settings are returned to their initial factory defaults.

Perform a full reset whenever any one of the following conditions exists.

•When you want to delete all memory contents and return the settings to their initial factory defaults.

•When you are no longer able to use the Handheld Terminal because you forgot your password.

•When the Handheld Terminal does not operate normally due to a memory problem.

•When the message “A problem with memory contents has been found. ...” appears.

To perform a full reset

Important!

Performing a full reset deletes all data currently stored in the memory (RAM). If possible, backup data of the Handheld Terminal to a computer, Flash Memory, a memory card, or some other medium before performing a full reset.

1.While the Handheld Terminal is turned on, hold down the power key and push down the reset button for about one second, until the message shown below appears on the display.

Memory All Clear Warning

Proceeding with this operation initializes memory.

Press [R trigger key] to proceed

or [L trigger key] to cancel.

L trigger	R trigger
key	key
	Fn

•To cancel the full reset operation, press the L Trigger key instead of the R Trigger key.

2. Press the R Trigger key. This causes the message shown below to appear.

Memory All Clear Warning

Proceeding with this operation deletes all

data stored in memory.

Press [R trigger key] to proceed

or [L trigger key] to cancel.

L trigger	R trigger
key	key
	Fn

•To cancel the full reset operation, press the L Trigger key instead of the R Trigger key.

3. Press the R Trigger key again.

•Full reset is performed, all data in the memory (RAM) are erased and the start-up screen is displayed.

E-34