Full Reset (Memory Initialize)
Full reset (memory initialize) deletes all data, and resets all unit parameters to their initial defaults.
The following are conditions when you should perform a full reset.
∙When you want to delete all memory data and return unit settings to their factory defaults
∙When you forget your password and need to clear it
∙When a data error causes operational problems
∙Appearance of the message: “A problem with memory contents has been found...”
Performing a Full Reset
Important
∙The following procedure deletes all data in memory. Be sure that data is backed up or that you no longer need it before performing the following procedure.
∙If there is a CompactFlash card in the CASSIOPEIA’s slot, remove the card before performing the full reset.
1.Make sure that unit power is turned on.
2.While holding down the [Power] button, use the stylus to hold down the RESET button for about two seconds.
∙This causes the following message to appear on the display screen.
“Proceeding with this operation initializes memory. Press [Action] to proceed or [Start] to cancel.”
3. Press the [Action] control.
∙This causes the following message to appear on the display screen.
“Proceeding with this operation deletes all data stored in memory. Press [Action] to proceed or [Start] to cancel.”
4. Press the [Action] control again.
∙This starts the full reset operation, which deletes all data in memory.
∙Pressing the [Action] control displays the Startup screen. Perform steps 5 through 6 under “Initial Setup” on page 12 to set up the unit.
You can abort the full reset operation while the messages in steps 2 and 3 are on the display by pressing the [Start] button.
34
