Casio EX-TR100 Lamp Status, Description, Back Lamp Operation, 5.Connect the USB cable to the camera

5.Connect the USB cable to the camera.

The back lamp should		USB-AC adaptor
light red, indicating that
charging has started.
The back lamp will go
out when charging is		[USB] port
complete.
•	It takes about
	130 minutes to bring a	Small connector
	fully dead battery to a
		USB cable
	full charge.
		(included with camera)
•	A battery that has not
	been used for a long
	time or ambient	Making sure that the 8 mark on the USB cable
	temperature extremes
		connector is towards the side opposite that of the monitor
	can cause charging to
		screen, connect the cable to the camera.
	take longer than
	normal. If charging
	takes longer than
	about six hours, a timer will terminate it automatically, even if the battery is not
	fully charged. This is indicated by the back lamp flashing red. If the battery has
	not been used for a very long time, charging may be terminated automatically
	and the back lamp may start flashing red after only about 45 minutes. In either
	case, disconnect the USB cable from the camera and then reconnect it to
	resume charging.
•	Note that even while the connector is fully inserted, you
	still will be able to see the metal part of the connector as
	shown in the illustration.

Back Lamp Operation

Lamp Status	Description	Back lamp
Lit Red	Charging
	Abnormal ambient temperature, USB-AC
Flashing Red	adaptor problem, or battery problem
	(page 109), or charging terminated by the
	timer
Off	Charging complete

6.After charging is complete, disconnect the USB cable from the camera and then unplug the adaptor from the power outlet.

19 Quick Start Basics