VIEWING IMAGES ON A COMPUTER
Using the Camera with a Macintosh Computer
The following are the general steps for viewing and copying files from a Macintosh.
You can find details about each operation in the procedures that follow below. Note that you should also refer to the documentation that comes with your Macintosh for other information about USB connections, etc.
IMPORTANT! 
•This camera does not support operation on a computer running Mac OS 8.6 or lower, or Mac OS X 10.0. If you have a Macintosh running Mac OS 9 or OS X (10.1, 10.2, 10.3 or 10.4), use the standard USB driver that comes with your OS.
1.Load the fully charged batteries into the camera, and configure the required camera settings for USB connection to a computer.
2.Use the USB cable to establish a connection between the camera and your Macintosh.
3.View and copy the images you want.
IMPORTANT! 
•Low battery power can cause the camera to power down suddenly during data communication. Use the optional AC adaptor is recommended to power the camera during data communication with a computer.
•If you want to transfer files from the camera’s
200