Casio EX-ZS100 Power Supply, Charging, To replace the battery, the current battery, 2.Load a new battery, 1. Open the battery cover and remove

Any and all unauthorized commercial copying, distribution, and copying of the bundled software over a network are prohibited.

This product’s YouTube upload functionality is included under license from YouTube, LLC. The presence of YouTube upload functionality in this product is not an endorsement or recommendation of the product by YouTube, LLC.

Power Supply

Charging

.If the camera’s back lamp starts flashing red...

•Ambient temperature or the temperature of the battery may be either too high or too low. Disconnect the USB cable and wait until temperature is within the allowable charging range before trying again.

•Battery contacts may be dirty. Wipe them with a dry cloth.

•Try connecting to a different computer USB port. Depending on the setup of your computer, you may not be able to charge the camera’s battery over a USB connection.

If problems continue to occur after you perform the above steps, it could mean that the battery is faulty. Contact your nearest CASIO authorized service center.

To replace the battery

1. Open the battery cover and remove	Stopper
the current battery.

With the monitor screen side of the camera facing upwards, slide the stopper in the direction indicated by the arrow in the illustration. After the battery pops out, pull it the rest of the way out of the camera.

2.Load a new battery.

119 Appendix