Disp
The display currently shows an intermediate result of a
Important: For some type of calculation that takes a long time to execute, the display may show only the above indicators (without any value) while it performs the calculation internally.
Using Menus
Some of the calculator’s operations are performed using menus. Pressing N or w, for example, will display a menu of applicable functions.
The following are the operations you should use to navigate between menus.
•You can select a menu item by pressing the number key that corresponds to the number to its left on the menu screen.
•The $indicator in the upper right corner of a menu means there is another menu below the current one. The ` indicator means another menu above. Use c and f to switch between menus.
•To close a menu without selecting anything, press A.
SpecifyingtheCalculation Mode
When you want to perform this type of | Perform this key |
operation: | operation: |
|
|
General calculations | N1(COMP) |
|
|
Complex number calculations | N2(CMPLX) |
|
|
Statistical and regression calculations | N3(STAT) |
|
|
Calculations involving specific number |
|
systems (binary, octal, decimal, | |
hexadecimal) |
|
|
|
Equation solution | N5(EQN) |
|
|
Matrix calculations | N6(MATRIX) |
|
|
Generate a number table based on one or | N7(TABLE) |
two functions |
|
Vector calculations | N8(VECTOR) |
|
|
Inequality solution | Nc1(INEQ) |
|
|
Verify a calculation | Nc2(VERIF) |
|
|
Distribution Calculations | Nc3(DIST) |
|
|
Note: The initial default calculation mode is the COMP Mode.
Configuringthe Calculator Setup
First perform the following key operation to display the setup menu: 1N(SETUP). Next, use c and f and the number keys to configure the settings you want.
Underlined ( ___ ) settings are initial defaults.