
•Norm: Selecting one of the two available settings (Norm1, Norm2) determines the range in which results will be displayed in non- exponential format. Outside the specified range, results are displayed using exponential format.
Norm1:
Norm2:
Example: 1 ⎟ 200 = 5 ⋅ | (Norm1) |
0.005 | (Norm2) |
Specifying the Fraction Display Format
To specify this fraction
display format:
Perform this key operation:
Mixed1Nc1(ab/c)
Improper1Nc2(d/c)
Specifying the Complex Number Display Format
To specify this complex
number format:
Perform this key operation:
Rectangular Coordinates 1Nc3(CMPLX)1(a+bi)
Polar Coordinates 1Nc3(CMPLX)2(r∠θ)
The complex number display format specifies the display format to be used for complex number solutions produced by equation operations in the EQN Mode.
Specifying the Statistical Display Format
Use the following procedure to turn display of the frequency (FREQ) column of the STAT Mode STAT editor screen on or off.
To specify this: | Perform this key operation: |
Show FREQ Column 1Nc4(STAT)1(ON)
Hide FREQ Column 1Nc4(STAT)2(OFF)
Specifying the Decimal Point Display Format
To specify this decimal
point display format:
Perform this key operation:
Dot (.)1Nc5(Disp)1(Dot)
Comma (,)1Nc5(Disp)2(Comma)
•The setting you configure here is applied for calculation results only. The decimal point for input values is always a dot (.).