Handling the Neck Strap
A neck strap can be attached to the Handheld Printer Terminal to keep it from being dropped while being carried. The stylus holder provided can also be attached.
Neck strap rings* Adjust length here
Stylus holder
Mounting | Neck strap |
| |
hooks |
|
Attach the neck strap following the procedure described below.
Attaching
1. Pull out the neck strap mounting hooks out of each silo on the bottom of the Handheld Printer Terminal using the tip of stylus. (On models with a magnetic card reader, the hooks are located at the bottom of the terminal on the back of the reader.) Hook the protrusive part (**) of the ring on the neck strap mounting hook as shown in the illustration. While slightly pushing the ring, turn the ring until all part of it is fully hooked.
** The ring is very stiff for the first time. | The illustration shows the |
| |
A small flat screw driver is helpful by |
|
inserting it into overlapped part of the |
|
ring to make a room when hooking the |
|
protrusive part. |
|
2.Pull back the locking bar of the neck strap mounting hook and then hook the mounting hook onto the ring as shown in the illustration.
•* ; The rings give an extra mechanical strength for the Neck Strap. The metallic hooks of the Neck Strap can, in rare case, be worn by abrasion induced by swinging the