Casio KL-100E • Text Input, • Tape Cutting, ESC, FUNC, FUNC, E-20, Action, Action, Action, Action, Action, Action, Action, Important, Important, Important, Possible Cause

• Text Input

	Cannot input text.
Possible Cause	Action
FUNC key has been	Press ESC to clear FUNC key operation.
pressed.
Tape does not come out when PRINT is pressed.
Possible Causes	Action
Back cover is not closed	Securely close the back cover.
completely.
No more tape left in the	Replace the tape cartridge with a new one.
cartridge.
Tape jam	Remove the tape cartridge and pull out the
	jammed tape by hand. Cut off excess tape with
	scissors, and carefully replace the cartridge into
	the label printer.
	Important!
	Never allow the tape outlet to become blocked
	and never touch tape as it is being fed during
	printing.

Tape comes out when PRINT is pressed, but nothing is printed on it.

Possible Cause	Action
Only blank spaces were	Input the text you want to print.
input.
Printing is blurred, blotched, broken, etc.
Possible Causes	Action
Improper print density set-	Adjust the print density setting.
ting
Improper loading of the	Remove the tape cartridge and reload it cor-
cartridge	rectly.
Dirty print head or rubber	Clean the printer head and roller.
roller

Ink ribbon is being fed from the tape outlet along with the tape.

Possible Cause	Action
Ink ribbon cassette loaded	Remove the ink ribbon cassette and check to
while the ink ribbon is	make sure the ink ribbon is not broken. Next,
slack.	take up any slack in the ink ribbon and then
	reload the tape cartridge.

	Important!
	• Before loading an ink ribbon cassette into
	the label printer, always make sure you take
	up any slack in the ink ribbon first.
	• If the ink ribbon is broken, you must change
	to another ink ribbon cassette.
• Tape Cutting
	Cannot cut tape.
Possible Cause	Action
Tape cutter blade is dull.	Take the label printer to the dealer from whom
	you purchased it to have the tape cutter blade
	replaced.
Printed text is cut off by tape cut operation.
Possible Causes	Action
The printer is set up for	Be sure to press the FEED key before perform-
manual tape feed.	ing the tape cut operation.
	Important!
	When the printer is set up for manual tape feed,
	the tape is not fed automatically after printing
	is complete.
Out of tape	Replace the tape cartridge with a new one.

E-20