Insert the adaptor cap into the ADAPTOR CAP holder located inside the cover to avoid losing the cap.
Press the cover release and open the cover.
To connect the AC adaptor
Connect the adaptor to the Label Printer as shown in the illustration. Plug the other end into a standard household AC outlet.
Inside cover
ADAPTOR CAP holder
5.Press SET to initialize the Label Printer or ESC to abort the reset operation without initializing anything.
∙See “Initializing the Label Printer” on page
Auto Power Off Function
If you do not perform any key operation for about six minutes, the Label Printer automatically turns power off. To restore power, press ON/OFF.
Tape Cartridges
Use the procedures described below to load a tape cartridge into the Label Printer.
Important!
Turning Power On and Off
Press ON/OFF to turn power on and off.
Important!
∙If you are using the Label Printer for the first time, you should reset it first.
Resetting the Memory
You should reset the memory of the Label Printer before using it for the first time, after you have not used it for a long time, or if nothing happens when you turn power on, even after you change the batteries.
Important!
∙Resetting Label Printer memory clears its memory of all input data.
To reset the memory
1.Make sure that Label Printer power is off.
2.While holding down the PRINT and ESC keys, press ON/OFF to turn power on.
3.Keeping PRINT and ESC held down, release the ON/OFF key only.
4.Release ESC, and then PRINT.
I N I T I A L ?
∙Never try to push the tape back into the cassette. Once tape is out of the cassette, there is no way to wind it back in. Trying to do so can cause opera- tional problems with the Label Printer.
∙The following are the tape widths that can be used with this printer: 6mm, 9mm, 12mm, 18mm, 24mm.
To load a tape cartridge
1.Make sure that the Label Printer is turned off.
2.Press the cover release and open the cover.
∙ If there is a cartridge already in the Label Printer, remove it by grasping the cartridge on both sides with your thumb and forefinger, and lift straight up.
3.Remove the stopper from a new tape cartridge and check to see that the tape is ready to use.