Casio KL-750 INT, Troubleshooting, To initialize the Label Printer, ESC, ESC, SET, ESC, Item, E-16, PRINT, PRINT, Reset, Action, Problem, Possible Cause

To initialize the Label Printer

1.	Turn power off.
2.	While holding down the PRINT and ESC keys,	INT?
	press ON to turn power on.
3.	the ON key only.
	Keeping PRINT and ESC held down, release

•This prompt confirms whether or not you want to initialize the Label Printer.

4.Press SET to initialize the Label Printer or ESC to abort the reset operation.

• The following table shows the initial settings.

Item	Reset
Display	Cleared
Memory	Cleared
SYMBOL	,
EFFECT	CANCEL
M-FEED	NO
MIRROR	OFF
MEMO	STR?
DENSITY	3
WIDTH	OFF

Troubleshooting

Problem	Possible Cause	Action
ERR! message	• Attempt to input two ¥	• Use only one ¥ mark.
on the display.	marks within the same	Only two lines of text
	text.	can be input, so text
		can contain only one
	• Attempt to input ¥	¥ mark.
		• Do not use ¥ marks.
	mark while 6mm is	6mm tape can have
	specified as the tape	only one line of text,
	width.	so text cannot contain
	• Label text containing a	any ¥ marks.
		• Delete the ¥ mark to
	¥ mark was input and	print on 6mm tape or
	then tape width	switch back to a wider
	specification was	tape.
	changed to 6mm.
	(ERR! message appears
	when you try to perform
	a print operation.)
	• Text that is longer than	• Shorten the text to be
	5.5cm when stamp	printed and try again.
	printing is selected.
	• Attempt to print a stamp	• Change the tape width
	while 6mm is specified	setting to OFF and try
	for the tape width.	printing the stamp
		again.
FUL! message	• Both text memory areas	• Delete text from one of
on the display.	(AREA 1 and AREA 2)	the text memory areas
	already contain text.	and then store the new
		text.
BATT message	• Battery power is too	• Replace batteries.
on the display.	low.
ERR! message	• Memory data has	• Initialize the Label
on the display.	become corrupted for	Printer.
	some reason.
		E-16