To replace the batteries

1. Turn power off.

If you are using the optional AC adaptor for power, you should also unplug it from the Label Printer.

2. Open the battery compartment cover on the back of the Label Printer by sliding it in the direction indicated by the arrow.

3. Remove all eight of the old batteries.

4. Load a set of eight new batteries into the battery compartment, making sure that their positive (+) and negative (–) ends are facing in the correct directions.

5. Replace the battery compartment cover.

AC Adaptor

Note the following important precautions when using an AC adaptor to power your Label Printer.

Use only a genuine CASIO AD-A95100 AC adaptor with the same voltage rating as the household current in your area. Using a wrong adaptor can damage your Label Printer.

Be sure to turn the Label Printer off before you connect the adaptor. Do not turn power on until the adaptor is connected to the Label Printer and plugged into and AC outlet.

Be sure to unplug the AC adaptor from the AC outlet whenever you are not using the Label Printer.

To connect the AC adaptor

Connect the adaptor to the Label Printer as illustrated nearby. Plug the other end into a standard household AC outlet.

Turning Power On and Off

Press ON to turn power on, and OFF to turn power off.

Important!

If you are using the Label Printer for the first time, you should reset it first.

Resetting the Memory

You should reset the memory of the Label Printer before using it for the first time, after you have not used it for a long time, or if nothing happens when you turn power on, even after you change the batteries.

Important!

Resetting Label Printer memory clears its memory of all input data.

To reset the memory

1.

Make sure that Label Printer power is off.

 

2.

While holding down the PRINT and ESC keys,

INT?

 

press ON to turn power on.

3.

the ON key only.

Keeping PRINT and ESC held down, release

 

4.Press SET to initialize the Label Printer or ESC to abort the reset operation without initializing anything.

See “Initializing the Label Printer” on page 15 for information on the initial default settings of the Label Printer following the reset operation.

Auto Power Off Function

If you do not perform any key operation for about six minutes, the Label Printer automatically turns power off. To restore power, press ON.

Tape Cartridges

Use the procedures described below to load a tape cartridge into the Label Printer. After you load the tape cartridge, be sure to use the procedure described under “Tape Width Specifications” on page 6 to tell the Label Printer what is the width of the tape you are using.

E-5