Operation Guide 4343

Home Position Adjustment

If the time setting of your watch is not correct even though time calibration signal reception is being performed normally, use the procedure in this section to check the home positions of the hands and make adjustments as required. Note that you do not need to perform the following operation if your watch is showing the correct time.

3.

Press the Cbutton.

Hour and Minute Hands

 

This will cause the hour hand,

24-hour Hand

 

 

minute hand, and 24-hour

 

 

hand to move to their home

 

 

positions.

 

 

Home Position

 

 

Hour Hand: 12 o’clock

30

 

 

5.

Press the Cbutton.

Chronograph Hands

 

This will cause the

 

 

chronograph hour and minute

 

 

hands to move to their home

 

 

positions.

 

 

Home Position

30

 

 

 

Hour Hand: 24:00

 

1. In the Timekeeping Mode, hold down the Abutton and then the Cbutton for about five seconds.

The watch will beep, and then the indicator hand and the second hand will move their home positions.

Home Position

Indicator Hand: 12 o’clock

Second Hand: 0

Indicator Hand

30

Second Hand

If the indicator hand or second hand isnot at its proper home position

2. Use the Bbutton to adjust the position of the indicator hand and the Cbutton to adjust the position of the second hand.

The hands move

30

 

 

clockwise only. Keep

 

 

pressing the buttons

 

 

until the applicable

 

 

hand is at its proper

 

Minute Hand: 12 o’clock

24-hour Hand: 24:00

If the hour, minute, and 24-hour hands are all at their proper home positions, advance to step 5.

If the chronograph hour and minute hands are not at their proper home positions

4. Use the D(+) and

B(–) buttons to adjust the hands.

Minute Hand: 24:00

If the hour and minute hands are at their proper home positions, advance to step 7.

If the chronograph hour and minute hands are not at their proper home positions

6. Use the D(+) and

B(–) buttons to adjust the hands.

If the indicator hand and second hand are both at their proper home positions, advance to step 3.

home position.

30

Holding down either button will cause the hands to move at high speed. Once started, high-speed hand movement will continue even if you release the button. To stop high-speed hand movement, press any button.

The 24-hour hand is synchronized with the hour and minute hands, so separate adjustment is not required.

30

Holding down either button will cause the hands to move at high speed. Once started, high-speed hand movement will continue even if you release the button. To stop high-speed hand movement, press any button.

7. Check the day indicator. If it is not at its home position, use the C button to move it there.

 

1

Home Position

 

Day 1

Day

 

If the Day is at its proper home position, advance to step 9.

If the Day is not at its proper home position

8. Use the D(+) and B(–) buttons to adjust the day.

1

Holding down either button will cause the day to change at high speed. Once started, high-speed day change will continue even if you release the button. To stop high-speed day change, press any button.

9. Press the Abutton to exit home position adjustment and return to the Timekeeping Mode.

If you press the Cbutton

30

instead of the Abutton in step 1, the watch will return to step 1 (indicator hand and second hand home position adjustment) of this procedure.

The watch also will exit home position adjustment automatically if you do not perform any operation for about two or three minutes.

After completing the home position adjustment procedure, put the watch in a location where it is able to receive the time calibration signal easily and perform a manual receive operation.

For details about the manual receive procedure, see “Receiving the Calibration Signal”.

7