IMPORTANT!

•Recorded images are transferred over wireless LAN. Do not use the Eye-Fi card or turn off Eye-Fi card communication (page 134) when on an aircraft or in any other location where use of wireless communication is limited or prohibited.

•Loading an Eye-Fi card will cause the Eye-Fi indicator to

appear on the monitor screen. Its transparent or not transparent appearance indicates the communication status as shown below.

Transparent

 

Access point cannot be found or no

 

transferable image data exists.

 

 

Not transparent

 

Image transfer in progress

 

 

 

Flashing

 

Searching for access points

 

 

 

•A communication icon will appear on the monitor screen while image data transfer is in progress.

•The camera’s Auto Power Off (page 141) function is disabled while image data transfer is in progress.

•A confirmation message will appear on the monitor screen if you try to turn off the camera while image data transfer is in progress. Follow the instructions in the messages (page 164).

•Transfer of a large number of images can take some time to complete.

•Depending on the type of Eye-Fi card you are using and its settings, images on the Eye-Fi card may be deleted following image data transfer.

•When recording a movie to an Eye-Fi card, it can take too much time to record data, which can result in breaks in the image and/or audio.

•Proper Eye-Fi card data communication may not be possible due to camera settings, battery level, or operating conditions.

•Use of an Eye-Fi X2 card is not recommended.

C

130

Using the Camera with a Computer